TimberTech Deck Cost in New Hampshire
A TimberTech deck in New Hampshire costs $51-$128/sqft installed with the state's 1.22× labor multiplier (Northeast). TimberTech (owned by AZEK Company) makes 3 lines: Edge Prime+ (capped composite entry), Pro Legacy (premium capped composite), and AZEK Vintage/Harvest/Arbor (cellular PVC top tier). PVC lines outperform composite on heat + moisture but cost ~20-30% more. New Hampshire labor 1.22× national. Frost depth 48″.
TimberTech cost by deck size in New Hampshire
Mid-tier TimberTech (TimberTech Pro Legacy) at New Hampshire's 1.22× labor multiplier — ~$71/sqft installed.
Cost ranges include materials + labor + standard railing. Excludes permit ($320 baseline + 1.2% of project value), demolition (if replacing), and footings for 48″ frost depth.
TimberTech product lines in New Hampshire
TimberTech installed cost ranges from $42/sqft (Edge Prime+ on PT framing) to $105/sqft (AZEK Harvest on premium railing). The PVC lines (AZEK Vintage Mahogany / AZEK Harvest Slate Gray) command the top of the range — multiply by your state labor multiplier.
New Hampshire-specific notes
Get a precise TimberTech quote for New Hampshire
Open the TimberTech Deck Calculator with NH pre-selected to dial in your exact size, board line, and railing choices.
FAQ — TimberTech in New Hampshire
How much does a TimberTech deck cost in New Hampshire?▾
In New Hampshire, TimberTech decking costs $51-$128/sqft installed (national $42-$105/sqft × New Hampshire's 1.22× labor multiplier). A typical 16×20 (320 sqft) TimberTech deck lands around $28,800. Mid-tier TimberTech Pro Legacy runs about $22,720 for the same scope.
Which TimberTech line is best for New Hampshire's climate?▾
New Hampshire's freeze-thaw cycles favor PVC over composite where budget allows. TimberTech AZEK Vintage works well in snow regions when properly fastened with the right expansion gap.
What's the permit fee for a TimberTech deck in New Hampshire?▾
New Hampshire permit fees typically run $240-$592 depending on jurisdiction and project value — most calculators use max(regional baseline $320, 1.2% of project value). NH permits $200-340.
How deep do footings need to be for a TimberTech deck in New Hampshire?▾
New Hampshire's frost depth is approximately 48″. TimberTech doesn't change the footing requirement — that's IRC R403.1.4-driven by frost line. Use Sonotube 12-14″ to handle the deep footings. Verify with your local building department since AHJs sometimes require deeper depths than the state-published value.
Is TimberTech worth the money in New Hampshire?▾
TimberTech vs PT pine over 25 years in New Hampshire: PT pine = ~$37/sqft installed + ~$3/sqft/yr maintenance (stain/seal annually) = $113/sqft total. TimberTech mid-tier = $71/sqft installed + $0 maintenance = $71/sqft total. TimberTech typically wins the 25-yr TCO comparison by 20-40%, plus better resale value.